RadiSys EPC-8A Especificações Página 42
- Página / 156
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
EPC-5A Hardware & Software Reference Manual
44
Page 34
Boot Options Sub-menu
Use the Boot Options sub-menu to change the boot sequence options. Select the Boot
Options sub-menu by clicking on the Boot Sequence item in the Main BIOS Setup
screen. The Boot Options Sub-menu is shown below.
PhoenixBIOS Setu
p
- Co
py
ri
g
ht 1985-96 Phoenix Technolo
g
ies Ltd.
Item S
p
ecific Hel
p
F1 Hel
p
Select Item -/+ Chan
g
e Values F9 Setu
p
Defaults
ESC Exit Select Menu Enter Select Sub-Menu F10 Previous Values
<Tab>, <Shift-Tab>, or
<Enter> selects field.
Boot Dela
y
: [0]
Boot Options
Flo
ppy
Check: [Enabled]
POST Errors: [Enabled]
SETUP Prom
p
t: [Enabled]
Boot Se
q
uence:
[
A: then C:
]
Summar
y
Screen: [Enabled]
Figure 4-5. Boot Options Sub-menu.
Boot Delay
Use this option to set the system to delay booting for a time period from 0 through 255
seconds. This allows for long start up times on boot devices that spin up slowly. The
default is “0” seconds.
Boot Sequence
This option is used to define how the system treats floppy drive A: when booting.
Booting can occur from a floppy in the A: drive or directly from the fixed disk drive.
To reduce the amount of time required to boot, the boot sequence should be set to “C:
only”. Note that the C: drive may be either an IDE, VME or Flash drive. The options
are as follows:
1. A: then C: Used to boot from the floppy drive, or if no floppy disk is
present in the A: drive, boot from the C: drive.
- Hardware & Software 1
- Reference Manual 1
- Hardware Warranty 3
- Table of Contents 4
- List of Illustrations 7
- List of Tables 8
- 1. Product Description 9
- Notational Conventions 10
- Product Overview 11
- Specifications 12
- 2. Before Installation 15
- Product VME Slots Total 17
- VMEbus Slots 18
- J1 Connector 21
- 3. Installation 23
- EXP-BP2 Subplane 24
- Chapter 3: Installation 25
- EXP-BP4 Subplane 25
- EXP-BP3A Subplane 26
- EXP-BP5 Subplane 27
- EXP-BP4A Subplane 28
- EXP-BP6 Subplane 29
- EPC-5A Insertion 30
- EXM Module Insertion 32
- Keyboard 33
- Serial Ports 34
- Parallel Printer Port 34
- 4. BIOS Configuration 35
- Main BIOS Setup Menu 37
- Chapter 4: BIOS Configuration 39
- IDE Adapter Sub-menus 39
- Memory Shadow Sub-Menu 41
- Boot Options Sub-menu 42
- Keyboard Features Sub-menu 44
- Advanced Menu 45
- EXM Menu 47
- VME Menu 50
- Exit Menu 52
- 5. Theory of Operation 55
- Memory Map 57
- Peripheral Components 58
- Real Time Clock 58
- Keyboard Controller 59
- ROM and ROM Shadowing 59
- Embedded Shadow 59
- Bootable Device Precedence 59
- Video Controllers 61
- Front Panel LEDs 61
- Resetting the EPC-5A 62
- EXM Expansion Interface 62
- 6. The VMEbus Interface 63
- Concepts 64
- Direct VMEbus Accesses 65
- Byte Ordering 66
- Motorola 67
- Read-Modify-Write Operations 70
- VMEbus Interrupt Response 71
- VME Event Enable Register 74
- Interrupt Generator Register 74
- 11101100 Lower 75
- 100A321111 Upper 75
- 0 Slave Size 11111 Upper 76
- 11000100 Lower 76
- 11111111 Lower 77
- 00011 SLAVE BASE Upper 77
- 01011111 Upper 78
- LOCK 1 ABMH 1 1 ULA Lower 78
- 00001RRDY WRDY 1 Upper 78
- RAM Lower 79
- RAM Upper 79
- 11111ACFA BERR SYSF 81
- DONE AS DS0 DS1 1 1 (res.) 1 82
- 11111 INTERRUPT-OUT 82
- VMEbus Mapped Registers 83
- Supported Address Modifiers 84
- VMEbus Accesses 85
- 7. Connectors 93
- Parallel Port 94
- Speaker Header 95
- Battery Header 95
- 8. Upgrades 97
- Messages 99
- Common Error Messages 101
- EXM CONFIGURATION ERROR 103
- INVALID DRIVE SPECIFICATION 104
- MISSING OPERATING SYSTEM 105
- NON-SYSTEM DISK OR DISK ERROR 105
- PARITY ERROR IN SEGMENT 106
- PRESS A KEY TO REBOOT 106
- NOT READY READING DRIVE 106
- Page 101 107
- Boot Failures 108
- Phoenix NuBIOS Checkpoints 109
- 10. Support and Service 113
- Repair Services 114
- Warranty Repairs 114
- Non-Warranty Services 114
- Arranging Service 115
- Other Countries 116
- Page A-1 117
- Page A-2 118
- Page A-3 119
- Page A-4 120
- Page A-5 121
- Page A-6 122
- Appendix B: Interrupts and 123
- DMA Channels 123
- Appendix C: Flash Boot 125
- 28F004BV-T 126
- Flash Boot Device Reflashing 127
- Appendix C: Flash Boot Device 129
- Reflashing using REFLASH.EXE 130
- User BIOS Extensions 132
- PicoCard Flash File System 133
- Page C-10 134
- Appendix D 135
- Page D-4 138
- Appendix G: Glossary 139
- EPC-5A Hardware Reference 140
- Glossary 141
- Page I-VI 156
Manuais e produtos relacionados com Barebones PC/estação de trabalho RadiSys EPC-8A
(93 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.065 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais